Fujitsu FibreCAT TXF, Руководство по эксплуатации

Страница: 12 / 57

12 Operating Manual
FibreCAT TXF
Safety instructions Important information
V
CAUTION!
● Only transport the server in the original packaging or in packaging
that protects it from impacts and jolts.
●
Check that the rated voltage specified on the device's ID plate is the
same as the local line voltage.
●
This device must only be connected to a power outlet for the rack's
internal power supply using a tested and approved power cable.
●
Route the cables in such a way that they do not create a potential
hazard (make sure no-one can trip over them) and that they cannot
be damaged. When connecting the device, refer to the relevant
instructions in this manual.
● Never connect or disconnect data transmission lines during a storm
(lightning hazard).
● The system unit and the directly connected external backup
subsystems should be connected to the same power supply
distributor. Otherwise you run the risk of losing data if, for example,
the server is still running but the backup subsystem has failed during
a power failure.
● Make sure that no objects (such as jewelry, paperclips, etc.) or liquids
can get inside the device (risk of electrical shock, short circuit).
●
In emergencies (e.g. damage to housings, power cables or controls
or ingress of liquids or foreign bodies), immediately power down the
peripheral devices, pull out the power plugs and notify your service
department.
●
Note that proper operation of the system (in accordance with IEC
60950-1/DIN EN 60950-1) is guaranteed only if slot covers are
installed on all vacant slots and/or dummies on all vacant bays and
the housing cover is fitted (cooling, fire protection, RFI suppression).