Fujitsu Eternus DX80 S2, Руководство пользователя

Страница: 166 / 186

Appendix B Audit Log List
ETERNUS DX80 S2/DX90 S2 Disk storage system User’s Guide -Operation-
Copyright 2013 FUJITSU LIMITED P3AM-4842-12ENZ0
166
02060015 Set Host Response The host response parameters are set or changed.
$a
: Host response name
$b : Host response number
$c
: Load Balance Response (Busy, Queue-Full,
Unit-Attention)
$d
: Byte-0 of Inquiry Response (Disable, 7F,
20)
$e
: Inquiry VPD ID Type (Type1, Type1-3,
Type3)
$f
: Reservation Conflict Response (Enable,
Disable)
$g
: Command Timeout Interval [sec] (10 –
255)
$h
: Standard Data Version (3, 4, 5)
$i : Host Specific Mode (Normal, AIX, HP-UX,
Linux, BS2000)
$j : Symmetrical Access (Active, Passive)
$k
: Report of volume mapping modification
(Enable, Disable)
$l
: Report of expansion volume capacity modi-
fication (Enable, Disable)
$m
: Vendor Unique Sense Code (Enable,
Disable)
$n
: iSCSI Discovery Reply Mode (Port, All)
$o : Sense Data Conversion (None, Linux,
Windows, Custom)
$p : Sense Key for sense information before
conversion (0 – F or *)
$q
: Sense Code for sense information before
conversion (00 – FF or *)
$r : Additional Sense Code for sense
information before conversion (00 – FF or *)
$s : Sense Key for sense information after
conversion (0 – F or *)
$t
: Sense Code for sense information after
conversion (00 – FF or *)
$u : Additional Sense Code for sense
information after conversion (00 – FF or *)
$v : TPGS Mode (Enable, Disable)
$w
: TPG Referrals (Enable, Disable)
$x
: iSCSI Reservation Range (Port, System)
[Name=
$a
No=
$b
Status=
$c
Inquiry=
$d
Vpd=
$e
Conflict= $f Timeout= $g Version= $h Mode= $i
Symmetric=
$j
LUN_Change=
$k
LUN_Expand=
$l
Unique_Sense= $m iSCSI_Response= $n
Sense_Preset=
$o
[Sense_From=
$p
/
$q/$r
Sense_To= $s / $t / $u ] Tpgs_Mode= $v
Tpg_Referrals=
$w
iSCSI_Rsv_Range=
$x
]
02060016 Delete Host Response The host response is deleted.
$a : Host response name
[Name=
$a
]
02060017 Set CA Reset Group The CA Reset Group parameter is set or deleted.
$a : Port number (example: 001, 002)
[Port=
$a
]
02060018 Create Port Group The port group is created.
$a : Port group name
$b
: Port group number
$c
: Port number (example: 001, 002)
[Name=
$a
No=
$b
Port=
$c
]
02060019 Set Port Group The port group settings are changed.
$a : Port group name
$b
: New port group name
$c
: Port number (example: 001, 002)
[Name=
$a
New_Name=
$b
Port=
$c
]
Event code
Upper: Message
Description
Lower: Detailed information