En-5
Turn on the Power
Connect the Power Supply Plug (Fig. 1
J
) to an electrical outlet;
in the case of a direct line connection, turn on the circuit breaker.
Load Batteries (LR03
×××××
2)
1
Press and slide the battery compartment lid on the re-
verse side to open it.
Slide in the direction of the arrow while pressing the
mark.
2
Insert batteries.
Be sure to align the battery polarities (
+
/
-
) correctly.
3
Close the battery compartment lid.
Set the Current Time
1
Press the SET (TIMER) button (Fig. 5
j
)
Use the tip of a ball-point pen or other small object to press the button.
2
Use the
+
/
-
SET TIME buttons (Fig. 5
i
)to adjust
the clock to the current time.
+
button: Press to advance the time.
-
button: Press to reverse the time.
(Each time the buttons are pressed,the time will be advanced/reversed in
one-minute steps.hold the buttons depressed to change the time quickly
in ten-minute steps.)
3
Press the SET (TIMER) button.
This completes the time setting and starts the clock.
To Use the Remote Control Unit
●
The Remote Control Unit must be pointed at signal receiver (Fig. 2
4
) to operate
correctly.
●
Operating Range: About 7 meters.
●
When a signal is properly received by the air conditioner, a beeping sound will
be heard.
●
If no beep is heard, press the Remote Control Unit button again.
Remote Control Unit Holder
CAUTION!
●
Take care to prevent infants from
accidentally swallowing batteries.
●
When not using the Remote Control Unit
for an extended period, remove the
batteries to avoid possible leakage and
damage to the unit.
●
If leaking battery fluid comes in contact
with your skin, eyes, or mouth, immedi-
ately wash with copious amounts of
water, and consult your physician.
●
Dead batteries should be removed
quickly and disposed of properly, either
by placing in a public battery collection
receptacle, or by returning to appropriate
authority.
●
Do not attempt to recharge dry batteries.
Never mix new and used batteries, or
batteries of different types.
Batteries should last about one year
under normal use. If the Remote Con-
trol Unit’s operating range becomes ap-
preciably reduced, replace the batteries
and press the ACL button with the tip of
a ballpoint pen or other small object.
1
Mount the Holder.
2
Set the Romote Control
Unit.
3
To remove the Remote Con-
trol Unit (when use hand).
Screws
Insert
Press in
Slide up
Pull out
9312556014-En.pm6.5
2003.6.11, 5:08 PM
5
