En-14
COIL DRY OPERATION
●
When the COIL DRY button on the Remote Control Unit is pressed, the inside of the Indoor Unit is dried, and then the UV
(ultraviolet rays) lamp produces small amounts of ozone to suppress the growth of mold and various germs.
●
After the COIL DRY button is pressed, COIL DRY operation is performed for approximately 30 minutes and then automati-
cally stops.
To start COIL DRY Operation
Press the COIL DRY button (when the air conditioner is oper-
ating or stopped).
Only the OPERATION Indicator Lamp (red) on the Indoor Unit will light.
“COIL DRY” appears on the Remote Control Unit display and disappears after ap-
proximately 30 minutes.
If the COIL DRY button is pressed again during COIL DRY operation, COIL DRY op-
eration will start again.
To stop COIL DRY Operation
Press the START/STOP button during COIL DRY operation.
The OPERATION Indicator Lamp (red) on the Indoor Unit will go out.
●
The Remote Control Unit will be in the operation-stopped condition.
NOTE!
●
When COIL DRY operation begins, the
Indoor Unit operates in the heating
mode and the fan mode to dry the inside
of the Indoor Unit. As a result, the room
temperature and humidity may rise
slightly.
●
During COIL DRY operation, a small
amount of ozone and odor may be
produced.
●
COIL DRY operation cannot be used to
clean the air in the room.
●
COIL DRY operation is most effective
when performed frequently.
About COIL DRY Operation
The following procedures are performed during COIL DRY operation before the
operation automatically stops after approximately 30 minutes.
●
Drying (approximately 15 minutes)
After COIL DRY operation starts, the inside of the Indoor Unit is dried.
●
Ozone (approximately 15 minutes)
The UV (ultraviolet rays) lamp produces small amounts of ozone to suppress the
growth of mold and various germs.
●
COIL DRY operation stops
9312556014-En.pm6.5
2003.6.11, 5:08 PM
14
