Fujitsu AIRSTAGE UTY-ASGXZ1, Руководство по эксплуатации

Страница: 34 / 141

4.
Data acquisition application right click menu
32 Copyright© 2009-2017 Fujitsu General Limited. All rights reserved.
Analyzer type selection tab
Select the type of network topology analyzer from either “Type A” or “Type B”.
“Type A” is used for V-II and J-II series, and “Type B” for VR-II, J-IIS, J-III, J-IIIL,
V-III or later series.
If the analyzer type is incorrect, the correct results will not be displayed. Note
Adaptor selection
Selects the transmission adaptor which acquires the connection data.
Refrigerant system selection
Selects the intended refrigerant system address. The type is selected from all refriger-
ant systems or arbitrary refrigerant system range.
Refrigerant system range input
Enters the intended refrigerant of this function over the 00 to 99 range when “Ref. No.”
is selected at step .
“Perform System Initialization” check
When checked, the verification screen is displayed. When the [Yes] button is clicked,
all the units in the VRF system stop.
When the [No] button is checked, check mark is removed.
Start button
Starts this processing.
It takes up to 1 hour from start to the end of this process.
However, this process time may be shorten depending on the setting of or
.
Note
Progress bar
Displays the progress of this processing.
When Type B is used, the progress bar display shows the 1000 units of the maxi-
mum number of responding units as 100%. Consequently, check the progress
state by considering that the last display position depends on the number of
responding units. Note