En-12
(2) After wiring is complete, secure the remote controller
cable, connection cable, and power cable with the cable
clamps.
Connection cable
(to OUTDOOR UNIT or
BRANCH BOX)
Wired remote controller cable
Connect the connection cable to the terminal board.
Connect the remote controller cable to the terminal board.
Fix the remote controller cable to the control box cover with
a nylon clamp.
G
12
3
Cable tie
cable clamp
Wired remote controller cable
Connection cable
(to OUTDOOR UNIT
or BRANCH BOX)
(3) Install control box cover.
CAUTION
Do not wire the remote controller cable together with
or parallel to the connection cables, and power sup-
ply cables of the INDOOR UNIT and OUTDOOR UNIT,
BRANCH BOX. It may cause erroneous operation.
.
8. REMOTE CONTROLLER SETTING
CAUTION
When detecting the room temperature
using the remote controller, please
set up the remote controller accord-
ing to the following conditions. If the
remote controller is not located prop-
erly, the correct room temperature
will not be detected, and thus abnor-
mal conditions like “not cooling” or
“not heating” will occur even if the
air-conditioner is running normally.
• Locate where an average temperature for the room
being air conditioned will be sensed.
• Do not locate where it may be directly exposed to the
outlet air from the air-conditioner.
• Locate out of direct sunlight.
• Locate away from the in
fl
uence of other heat sources.
Do not touch the remote controller PC board and PC
board parts directly with your hands.
Do not wire the remote controller cable together with
or parallel to the connection cables, and power sup-
ply cables of the INDOOR UNIT, OUTDOOR UNIT, and
BRANCH BOX. It may cause erroneous operation.
When installing cable near a source of electromagnetic
waves, use shielded wire.
Do not set the DIP switches, either on the air condi-
tioner or the remote controller, in any way other than
indicated in the manual that is supplied with the air con-
ditioner. Doing so may result in improper operation.
8.1. Installing the remote controller
Open the operation panel on the front of the remote control-
ler, remove the 2 screws indicated in the following
fi
gure, and
then remove the front case of the remote controller.
When installing the remote controller, remove the connector
from the front case. The wires may break if the connector is
not removed and the front case hangs down.
When installing the front case, connect the connector to the
front case.
Screws
SET BACK
Front case
(back side)
Rear case
Connector
When remote controller cable is concealed
(1) Conceal the remote controller cable.
(2) Pass the remote controller cable through the hole in the
rear case and connect the remote controller cable to the
remote controller terminal board speci
fi
ed in
fi
gure.
(3) Clamp the remote controller cable sheath with the cable
tie as shown in
fi
gure.
(4) Cut off the excess cable tie.
(5) Install the rear case to the wall, box, etc., with 2 screws as
shown in the Example.
Temperature
sensor
9374318599-02_IM.indb 12
9374318599-02_IM.indb 12
9/26/2018 11:04:20 AM
9/26/2018 11:04:20 AM
