Fujitsu Siemens Computers SCENIC S 2, Руководство по эксплуатации, Страница: 37 / 72

A26361-K650-Z100-1-7619
29
Troubleshooting and tips
!
Take note of the safety notes in the "Safety and Ergonomics" manual and in the
"Preparation for use and operation" chapter, when you connect or disconnect cables.
If a fault occurs, try to correct it as described in the following places:
•
in this chapter
•
in the documentation of the connected devices
•
in the help systems of the software used
•
in the documentation of your operating system
If you fail to correct the problem, proceed as follows:
Ê
Switch the PC off.
Ê
Make a note of the steps and the circumstances that led to the fault. Also make a note of any
error messages displayed and the Identification number (Ident. No.) of your system.
Ê
Contact our help desk.
Installing new software
When installing programmes or drivers, important files may be overwritten and modified. To be able
to access the original data in the case of any problems following installation, you should backup
your hard disk prior to installation.
Power-on indicator remains unlit after you have
switched on your device
This may be due to the following:
The mains voltage supply is faulty
Ê
Check whether the power cable is properly plugged into the PC and grounded mains outlet.
Ê
Switch the PC on at the power switch.
Internal power supply overloaded
Ê
Remove the PC’s power plug from the grounded mains outlet.
Ê Wait for a moment.
Ê
Plug the power plug into the grounded mains outlet again.
Ê
Switch the PC on at the power switch.