③ △button (PB1)
Use this button to increase the mode date value on the display.
Data values differ depending on the selected mode.
④ ▼button (PB2)
Use this button to decrease the mode data value on the display.
⑤ SEL button (PB3)
Use this button to select a mode and load the data from the ROM.
⑥ ENT button (PB4)
Press this button to save the mode data on the display to the ROM. Data is not stored
if you change the mode by the SEL button.
Note: Mode ”C” and ”E” settings only work on the MK-3150V (horizontal
vibrator chute type.)
Simple Counter (Mode:”L”)
The simple counter can be selected by ON/OFF during MODE ”L”display.
Set MODE ”L”to ON to use the simple counter.
Use Mode ”M” to set the number of pieces you want to count up to.
Set Mode ”K”ON or OFF to select the count-up operation.
MODE ”L”ON：Displays the counter when the torque-up signal is input from
the screwdriver.
Press the ENT button to switch the display.
(The counter counts down. The MODE display LED is OFF while the counter value is displayed.)
A buzzer sounds (0.5 seconds) when the counter reaches 0.
Ignores the OK input when an external counter is connected.
MODE ”K”ON ： When the simple counter is ON, the pickup turns off when the count-up is reached
and the screw feed advances and stands by.
When the escape input is ON (short circuit),the pickup turns ON, and screw
feed is in retract.
Escape input serves as a reset signal when Mode ”K” is ON.
The escape opens or closes when Mode ”K” is OFF.
- 8 -
