64
6
65
CONNECTING AT DSC MODE
(USB)
socket
DC IN 3V
socket
Camera
1
PC
(USB)
socket
2
0
1
0
2
0
3
0
4
1
Load a SmartMedia containing photographed
images into your camera.
2
Slide the Power switch sideways to switch the
camera on.
3
Set the “USB MODE” setting in the “SET–UP”
menu to “DSC” (
➡
P.58).
4
Slide the Power switch sideways to switch the
camera off.
1
Switch your computer on.
2
Use the special USB cable to connect the camera to
your computer.
3
Switch the camera on.
Always use the prescribed procedure when
disconnecting or switching off the camera (
➡
P.68).
If you are connecting your camera to a Windows PC
for the first time, the “Add New Hardware Wizard”
window opens and driver software installation
begins (
➡
Software Quick Start Guide booklet).
●
!
You should use the AC power adapter when the camera
is connected to your computer (
➡
P.21). Loss of power
during data transmission can prevent successful data
downloading.
●
!
Ensure that you insert the USB cable plugs into the
correct sockets.
●
!
Push the cable plugs firmly into the connector sockets.
●
!
Switch the camera off when you change the
SmartMedia (
➡
P.68).
●
!
Do not disconnect the USB cable when the camera
is communicating with the computer. See P.68 for
information on the disconnection procedure.
i
The viewfinder lamp alternately blinks green
and orange while the camera is
communicating with your computer.
i
“DSC” appears on the LCD monitor.
i
Power Save/Auto Power Off does not function
when a USB connection is being used.
i
FinePixViewer automatically starts up.
i
A removable disk icon appears and you can
use your computer to transfer files to and from
the camera.
Camera Operation
Computer Operation
Windows
Macintosh
✽
Screen for Windows 98 SE
If the above operations do not occur, you do not
have the required software programs or drivers
installed on your computer. Refer to the
Software Quick Start Guide booklet and
complete the required computer setup
procedures. Then reconnect the camera to your
computer.
