3
FE
48
ELLIPTICAL
IMPORTANT
ELECTRICAL INSTRUCTIONS
WARNING!
• NEVER
remove any cover without first disconnecting AC
power supply.
•
If A.C. voltage varies by ten percent (10%) or more, the
performance of your elliptical may be affected. Such conditions
are not covered under your warranty. If you suspect the voltage is
low, contact your local power company or a licensed electrician
for proper testing.
• NEVER
expose this elliptical to rain or moisture. This product is
NOT designed for use outdoors, near a pool or spa, or in any
other high humid- ity environment. Maximum environmental
ratings are 40-120 degrees Fahrenheit, 95% humidity non-condensing
(no water droplets forming on surfaces).
IMPORTANT
OPERATION INSTRUCTIONS
NEVER
operate this elliptical without reading and completely understanding the results of any
operational change you request from the computer.
Understand that changes in resistance do not occur immediately. Set your desired level on the
computer console and release the adjustment key. The computer will obey the command
gradually.
NEVER
use your elliptical during an electrical storm. Surges may occur in your household
power supply that could damage elliptical components.
Use caution while participating in other activities while using your elliptical such as watching
television, reading, etc. These distractions may cause you to lose balance, resulting in serious
injury.
Always hold on to a handlebar while making control changes.
TRANSPORTATION
The elliptical is equipped with transport wheels, which are engaged when the rear of the
elliptical is lifted.
EXITING DISPLAY MODE
This product is preset to a DISPLAY MODE that keeps the console continually powered on. To turn this
feature off and allow your display to go into DISPLAY MODE when not being used, please use the follow-
ing procedure:
1. When in stand-by status, hold
Start, Stop
and
Enter
keys for five seconds to enter the Engineering
Mode.
2. Use the
/
keys to choose SELECT FUNCTION, then press the
ENTER
key.
3. Use the
/
keys to select the DISPLAY MODE, then press
Enter
key.
4. Use the
/
keys to turn ON or OFF the DISPLAY MODE function.
5. Hold the
Stop
key to save and exit Engineering Mode.
Plug-In
