FTS LYOSTAR 3, Руководство оператора

Страница: 13 / 82

Rev 006, 01/14 3
© SP Scientific 2014
Chapter
2
Getting Started
Initial Inspection
Your LyoStar™ 3 lyophilizer was carefully packed and thoroughly inspected before
leaving the factory. However, in the unlikely event that shipping damage has occurred,
retain all packing material and contact your freight carrier immediately.
DO NOT ACCEPT DAMAGED SHIPMENTS FROM A CARRIER WITHOUT A SIGNED
NOTIFICATION OF DAMAGES.
Upon receiving your shipment, inspect all contents of your equipment for damage.
Check packing material for small accessory items. Remove all packing material
carefully and inspect for concealed shipping damage. Inspect the inside of the
machine for any visible damage. If concealed damage or loss is discovered, contact
the freight carrier immediately.
1
Keep all contents, packing material and related
paperwork intact until a written report is obtained.
Note: SP Scientific will cooperate in the matter of collecting your claim, but is not responsible
for the collection or free replacement of the material. When possible, replacement parts will be
shipped and invoiced to you, making them a part of your claim.
Setup Procedure
The LyoStar™ 3 research & development lyophilizer is designed for single level
installation in either a machine room or cleanroom. The unit should be installed in a
location that is convenient for both operation and service.
Note: SP Scientific recommends installing your LyoStar™ 3 lyophilizers in an area equipped
with an adequate fire suppression system, as the system’s pressure relief devices are not
intended to withstand substantial increases in pressure due to extreme external temperatures
(e.g., such as in the event of a facility fire).
The following procedure will guide you with the setup of your LyoStar™ 3 lyophilizer.
Uncrate and unwrap the unit. 1.
Note: The LyoStar™ 3 and the control system workstation and peripherals
(e.g., printer) supplied with the control system are typically packaged separately.
1
“Concealed damage or loss” refers to damage or loss that does not become apparent until the merchandise has been
unpacked and inspected. Should damage or loss be discovered, you may make a written request for inspection by the carrier's
agent within 15 days of the delivery date. You may then file a claim with the freight carrier or SP Scientific, depending on the
terms of your shipment. If your shipment was “FOB Destination” file your claim with SP Scientific and include the inspection
report and any other supporting documents. If your shipment was “FOB Shipping Point” file your claim with the freight carrier
and include the inspection report and any other supporting documents.