User’s Manual · PVR ST180
Reserved of technical modifications and/or errors
-
38
-
PVR ST180
Version en_1.0
FTE maximal
Edit / Add Frequency
With the
Green
button
Edit
you can modify one frequency,
and with the
Yellow
button
Add
you can add one new frequency .
The use of
Add
and
Edit
is the same.
Please input here the middle frequency of one carrier.
Example:
CH 26 is from 510 up to 518 MHz
The correct frequency is 514MHz
In the line BW you have to select the bandwidth for this frequency.
Normally is in VHF band 7MHz, and in UHF 8MHz.
If everything is done, press
OK
button.
Skip Frequency
With this function it is possible to skip one frequency in the channels searching process.
The marked frequencies will not be checked when new channels are searched, so make sure before marking these
channels.
For marking the frequencies, select it with the buttons
and
and then press the
Blue
button
Skip
.
You can mark more than one frequency.
9.7. Channel Search: Terrestrial
This receiver has no pre programmed terrestrial channel list, because DVB-T
configuration changes in every different area.
Start the channel searching process by pressing the
Green
Button.
The receiver searches now in all TV frequencies.
You may stop searching by pressing the button
Exit
.
Once the search is finished, you must confirm if the new found channels have to be stored.
Press for confirm the
OK
-button.
Now you come back to menu
Channel Search
.
You can start a new search again, or you can close the menu now with the button
Exit
.
Search status
Current channel
Radio Channels
detected
Channels which the receiver
has found, currently 11
Signal Power and Quality
meter related to the selected
frequency