User’s Manual · PVR ST180
Reserved of technical modifications and/or errors
-
35
-
PVR ST180
Version en_1.0
FTE maximal
9.2. Antenna Configuration
In this menu you should configure the signals that are connected at the
inputs IF IN of your PVR.
By default, the equipment comes with the configuration that you can see in
the Picture with four satellites.
The available options in this screen allow:
Red
button: Deletes the selected satellite. It requests for confirmation.
Green
button: Edits the selected satellite. The option appears in the following
image.
Yellow
button: Adds a satellite. The options appear in the below image.
Antenna Options:
-
LNB Type: There are two available
bands: C and Ku. The difference is
basically the transmission frequency.
The Ku band has two possibilities,
the most common is the universal Ku.
-
Satellite: Your PVR is provided with
several satellites pre-stored. You can
find the one you want in the list or to
add a new one. They are sorted by
its orbital position. With the key
you can access to the available
satellite list.
-
Low Band / High Band: It is used
when the band selection is Ku one,
and it programmes the Local
Oscillators of the LNC.
-
DiSEqC 1.0 / 1.1 Ports: To configure the use of antenna switch. These switches allow the
reception of different satellites in a single input.
-
Motor: Enables the function of using a motor to direct the antenna.
-
22 KHz: Tone to switch the band of the LNC.
-
LNB Power: Feeding to the LNB. By default the selection is the one for an universal LNB.
-
Signal: It shows if there is an available signal in the selected configuration.
Alter whatever change, you should confirm with the OK button when you exit the menu.
9.3. Transponders Management
In the transponders management, we will have a screen like the following one:
With the
TV/R
they are
shown the TP of the C, Ku
or both bands.
UIT the
LIST
key you can
change the sort which with
the TP are shown. You can
change the sort of the TP
List, you can sort them by
frequency or by polarity.
With the
EPG
they are
shown the different pre-
stored satellites and when
you select whatever of
them, it is shown the TP of
this satellite.
Data block of TP where it is
shown the satellite frequency
of transmission, polarity,
symbol rate and FEC. Last
two columns are for the
selection of erasing and skip.