Frymaster Pasta Magic 17BC, Руководство по обслуживанию и запасным частям

Страница: 9 / 32

1-6
Insulator must seat in
hol e bef o re nu t i s
tightened.
Inside of cookpot.
1.3.7
Replacing the Temperature Probe
1.
Drain the cookpot and disconnect the cooker from the electrical
power supply.
2.
Remove the three screws along the upper edge of the control
panel and open the panel by allowing it to swing downward.
3.
Disconnect the 15-pin connector from the rear of the computer
and, using a pin pusher (such as Frymaster P/N 806-4855), push
out the temperature probe (red and white) leads from positions 13 and 14 on the connector.
4. Remove the temperature probe by unscrewing it from the front of the cookpot.
5.
Apply thread sealer to the replacement probe and screw it securely into the cookpot.
6.
Insert the red probe lead into position 13 of the 15-pin connector and the white lead into position
14. Pull gently on each lead to ensure it is firmly seated.
Insert red lead into position 13.
Insert white lead into position 14.
7.
Reattach the 15-pin connector to the rear of the computer, close the control panel, and replace the
three screws removed in Step 2.
1.3.8
Replacing the Pressure Regulator or Solenoid Valve
1.
Drain the cookpot and disconnect the cooker from the electrical power supply. Turn off or
disconnect the water supply to the cooker.
Testing Probe Resistance
A properly operating probe should
produce these resistances at these
temperatures:
•
552 Ω @ 60°F (16°C)
•
665 Ω @ 100°F (38°C)
•
1000 Ω @ 212°F (100°C)