Frymaster Pasta Magic 17BC, Руководство по обслуживанию и запасным частям

Страница: 6 / 32

1-3
1.3.2 Replacing Fuses
1.
The 15-amp fuses are located in holders mounted on front of the box.
2. Remove the cover and replace the fuse.
1.3.3 Replacing Electronic Components Other than the Computer
1.
Drain the cookpot and disconnect the cooker from the electrical power supply.
2.
Remove the covers from the component box.
3. On the component to be replaced, make a note of the wiring connection points.
4.
Disconnect the wires and remove the failed component. Install the replacement component and
reconnect the wiring in accordance with the notes made in Step 3 or with the wiring diagram on
the door of the unit.
5. Replace the component box covers, being sure to reconnect the ground wire. Reconnect the
cooker to the electrical power supply.
1.3.4 Replacing a Heating Element
1.
Drain the cookpot and disconnect the cooker from the electrical power supply. Disconnect the
unit from the water supply at the rear of the cooker. Remove the basket lift arms from the unit.
2.
Reposition the cooker to allow clear access to the rear of the unit. Remove the upper and lower
basket lift panels.
3. Unplug the element connector from the rear of the
component box. Depress the locking tabs on each side of
the connector and extend the connector to release the
element leads (see photo at right). Pull each of the leads out
of the connector, being careful not to damage the connector
in the process.
4.
If the bundle of element leads is enclosed in a fiberglass
insulating sheath, cut the wire ties securing the sheath in
place, and remove and discard it; it is no longer required. If
replacing the left element (as viewed from the front of the
cooker), cut the metal wire ties that secure the high-limit
thermostat to the element, being careful not to bend the
thermostat in the process.
5.
Remove the brass nuts that secure the element in the cookpot and lift the failed element from the
cookpot. Recover the Teflon washers from the failed element for use on the replacement.