Frymaster Pasta Magic 17BC, Руководство по обслуживанию и запасным частям

Страница: 11 / 32

1-8
Disconnect this
compression fitting.
Remove screws to remove the
faucet mounting plate.
Loosen this nut to separate
the faucet from the water
inlet manifold.
Remove this nut to separate the
faucet from the mounting plate.
5.
Separate the faucet from the water inlet manifold and mounting plate as shown in the illustration
at Step 4.
6.
Reverse Steps 1-5 to complete the procedure.
1.3.10 Replacing a Basket Lift Motor or Microswitch
1.
Disconnect the cooker from the electrical power supply.
2.
If rigid water connections have been used, disconnect the cooker from the incoming water
supply.
3.
Remove the basket lift arms from the lifter rods and then reposition the cooker to gain access to
the rear. Remove the upper and lower basket lift rear panels.
4.
Unplug the basket lift wiring harness from the lower 6-pin connector on the component box. (To
do this, you must reach around behind the component box from the front of the cooker.)
Disconnect basket lift wiring
harness from this connector.
5. Disconnect the basket lift link from the lifter cam (bell crank) assemblies one at a time. When
the link is disconnected from a cam, slip the corresponding lifter rod down and out of the
assembly (see illustration).