Frymaster Pasta Magic 17BC, Руководство по обслуживанию и запасным частям

Страница: 10 / 32

1-7
2. Loosen the compression fittings on the water lines running to and from the regulator and remove
the regulator from the unit. (
NOTE:
If the cooker is equipped with the optional Autofill feature,
the solenoid valve is installed between the regulator and the cookpot. If that is the case,
disconnect the solenoid leads and remove both the regulator and solenoid valve from the unit.)
Compression Fitting
Compression Fitting
Optional Solenoid Valve
Regulator must be rotated
to clear drain plumbing.
3.
If replacing the regulator, adjust the replacement regulator output pressure to not more than 40
PSI (28.15 kg/cm
2
) before installation in the cooker.
4.
Recover the fittings from the failed component (regulator or solenoid valve) and install them on
the replacement, using thread sealer on all connections.
5.
Reverse Steps 1 and 2 to complete the procedure, being sure to apply thread sealer to all
connections.
NOTE:
The regulator must be rotated approximately 45 degrees to clear the drain
plumbing (see illustration at Step 2).
1.3.9 Replacing the Water Faucet
1.
Drain the cookpot and disconnect the cooker from the electrical power supply.
2.
Turn off the water supply to the cooker and disconnect the incoming water lines where they
attach to the stubs at the rear of the cooker.
3.
Remove the two screws securing the access panel in place and remove the panel.
4.
Disconnect the water supply line at the compression fitting where it attaches to the water inlet
manifold. Remove the screws from the faucet mounting plate and lift the faucet assembly from
the unit.