Frymaster Pasta Magic 17/8BC, Инструкция по установке, эксплуатации и обслуживанию, Страница: 11 / 22

2-3
NOTE:
Depending on specific model ordered, either hot or cold water, or both, may be
connected to the unit. If available, connecting hot water will minimize the time required to
bring the unit to a boil when filling with fresh water.
NOTE: In order for the water level sensors to work properly, a certain amount of mineral
content in necessary in the water. For that reason, purified, deionized, or highly filtered wa-
ter should not be used.
5. Connect the desired drain plumbing to the drain valve. NOTE: Ensure drain plumbing is
connected in accordance with local codes. Waste water from the water bath unit
should not be discharged directly below the appliance. Rising steam can harm the
cabinet and the electrical components.
2.4 Connecting to the Electrical Supply
DANGER
This unit must be connected to the voltage and phase specified on the rating and serial
number plate located on the inside of the equipment door. To determine the appropriate
wire size, refer to the POWER REQUIREMENTS chart at the bottom of this page.
1. If the unit is not equipped with an installed power cord, open the door and remove the contactor
box cover. Position the unit to gain access to the rear and remove the lower back panel.
2.
Insert an appropriately rated power cord into the rear of the contactor box and make connections
in accordance with the applicable wiring diagram on the following page. Install a strain relief on
the power cord and replace the lower back panel and contactor box cover.
3.
Attach a plug that complies with national and/or applicable local codes to the free end of the
electrical power cord and plug the unit into an appropriate outlet.
POWER REQUIREMENTS
Use copper wire ONLY, suitable for at least 170ºF (75ºC)
17kW Cookers
Volts Phase Watts
Amps
(per leg)
Minimum
Wire Size
208 3P 60 Hz 8625 47 AWG 6 (4.1 mm)
240 3P 60 Hz 8625 41 AWG 6 (4.1 mm)
240/415 3P 4-wire, 50 Hz 8625 24 AWG 6 (4.1 mm)
8kW Cookers
200 Single 7400 37 AWG 6 (4.1 mm)
208 Single 8000 39 AWG 6 (4.1 mm)
220 Single 7300 34 AWG 6 (4.1 mm)
230 Single 8000 35 AWG 6 (4.1 mm)
240 Single 8000 34 AWG 6 (4.1 mm)
200 3P – Delta 7400 22 AWG 8 (3.3 mm)
208 3P – Delta 8000 23 AWG 8 (3.3 mm)
220 3P – Delta 7300 20 AWG 8 (3.3 mm)
230 3P – Delta 8000 21 AWG 8 (3.3 mm)
240 3P – Delta 8000 20 AWG 8 (3.3 mm)
200 3P – Wye 7400 13 AWG 8 (3.3 mm)
220 3P – Wye 7300 12 AWG 8 (3.3 mm)
230 3P – Wye 7400 11 AWG 8 (3.3 mm)