Frymaster FM45E, Руководство по установке и эксплуатации

Страница: 21 / 49

45 SERIES GAS FRYERS
CHAPTER 3: OPERATING INSTRUCTIONS
3-7
10.
selp
(Select Product) will again appear
in the left display. If more products are to
be programmed, return to Step 5 and fol-
low all instructions to this point, repeating
for each product.
11. When you complete your programming,
lock in the whole program by pressing the
Temperature Check/Program Lock switch
.
USING THE BOIL-OUT FEATURE
CAUTION
Before using this feature, ensure the
frypot is filled with a mixture of cold
water and
Frymaster
FRYER ‘N’
GRIDDLE
cleaner or detergent.
1. To program the fryer for boil-out, press the
Power switch (or ON/OFF ON
OFF
switch)
followed by the Program Mode switch .
Code
will appear in the left display.
2. Enter the code number
1653
. The right
display will read
boil boil boil boil
. The temperature is
automatically set for 195ºF (91ºC). The
fryer will attain this temperature and re-
main there until the Power
(or ON/OFF
ON
OFF
) switch is pressed, which cancels the
boil-out mode. In high-altitude locations,
the fryer must be monitored constantly for
boil-over conditions. If boil-over occurs,
turn off the fryer immediately, allow it to
cool, then re-enter the boil-out mode to
continue the boil-out process.
FRYER RECOVERY TIME CHECK FEATURE
“Recovery time” is the amount of time it takes
the fryer to increase the temperature from
275
°
F (135
°
C) to 325
°
F (163
°
C). It is a
measure of the fryer’s efficiency. It should be
no more than 2 minutes and 30 seconds. If the
recovery time is greater, call your FASC.
1. To check recovery time, press the Program
Mode switch .
Code
will appear in
the left display.
2. Enter the code number
1652
on the
number keypad. The recovery time will
appear in both displays for 5 seconds.
SELECTING FAHRENHEIT– CELSIUS DISPLAY
MODE
1. The computer can display temperatures in
either Fahrenheit or Celsius. To change
from one to the other, press the Program
Mode switch
.
Code
will appear in
the left display.
2.
Enter the code number
1658
on the
number keypad. The computer will toggle
the temperature display from Celsius to
Fahrenheit or from Fahrenheit to Celsius.
3. Press the Temperature Check/Program
Lock switch
to display the temperature
in the newly selected mode.
SELECTING FRYPOT TEMPERATURE DISPLAY
MODE
1. To display the actual frypot temperature at
all times, press the Program Mode switch
.
Code
will appear in the left display.
2. Enter code
165L
on both number key-
pads. The computer will display the actual
frypot temperature.
NOTE : During the
product cooking process, the cooking time
will not be displayed, but timing is taking
place.
3. To return to setpoint display, repeat Steps
1 and 2.