Fronius Virtual Welding 2.0, Руководство по эксплуатации

Страница: 11 / 152

11
EN
-U
S
Safety measures
at the setup loca -
tion and during
transport
Take care to ensure that the applicable national and regional guidelines and accident pre -
vention regulations are observed when transporting the device. especially guidelines con -
cerning hazards during transport and shipment.
Only carry out the transport in the original packaging. The original packaging is available
from the manufacturer.
Do not lift or transport any active devices. Switch off devices before transport or lifting.
Carry out internal instructions and checks to ensure that the vicinity of the workplace is al -
ways clean and organized.
After transport and before installation and commissioning, it is essential to visually inspect
the device for damage. Have a trained service technician repair any damage before instal -
lation and commissioning.
Safety measures
in normal opera -
tion
Only operate the device when all safety devices are fully functional. If the safety devices
are not fully functional, there is a danger of:
- Serious or fatal injury to the operator or third parties
- Damage to the device and other material assets belonging to the operating company
- Inefficient operation of the device
Safety devices that are not fully functional must be repaired before the device is switched
on.
Never bypass or disable safety devices.
Before switching on the device, ensure that no one can be put in danger.
The device must be examined at least once a week for externally detectable damage and
functionality of the safety devices.
Maintenance and
repair
It is impossible to guarantee that bought-in parts are designed and manufactured to meet
the demands made of them, or that they satisfy safety requirements.
- Use only original spare and wearing parts (also applies to standard parts).
- Do not carry out any modifications, alterations, etc. to the device without the manufac -
turer's consent.
- Components that are not in perfect condition must be replaced immediately.
- When ordering, please give the exact designation and part number as shown in the
spare parts list, as well as the serial number of your device.
The housing screws provide the ground conductor connection for earthing the housing
parts.
Only use original housing screws in the correct number and tightened to the specified
torque.
Safety Symbols
Devices with the CE label satisfy the essential requirements of the low-voltage and elec -
tromagnetic compatibility directive (e.g. relevant product standards of the EN 60974 se -
ries).
Fronius International GmbH declares that the device complies with Directive 2014/53/EU.
The full text of the EU Declaration of Conformity is available on the following website: http:/
/www.fronius.com