Fronius Virtual Welding 2.0, Руководство по эксплуатации

Страница: 10 / 152

10
If this is the case, then the operating company is obliged to take appropriate action to rectify
the situation.
Check and evaluate possible problems and the interference immunity of equipment in the
vicinity according to national and international regulations. For example, from:
- Safety devices
- Mains power lines, signal lines, and data transfer lines
- IT and telecommunications equipment
- Devices for measuring and calibrating
Supporting measures to avoid EMC problems:
a) Mains power supply
- Use only the supplied power cables
- If electromagnetic interference occurs despite a mains connection that complies
with regulations, take additional measures (e.g., use a suitable mains filter).
b) No modifications to the device
- Modifications made to the device without prior agreement with the manufacturer
may result in loss of type approval
c) If the device is suspected of interfering with the reception of television or radio signals
or the operation of another device:
- Confirm the device by switching it on and off as a source of interference
- If this identifies the device as a source of interference, remedy the fault using the
anti-interference measures listed below
d) Anti-interference measures
- Shield other devices in the vicinity
- Place the device far away from the affected receiver
- Turn the device away from the affected receiver
- Adjust the antenna of the affected receiver
- Connect the device to another AC socket so that the device and the affected re -
ceiver use different circuits.
- Only connect the device to a grounded socket. Removing the grounding may in -
crease high-frequency emissions and cause an electric shock resulting in death.
Do not use AC adapter plugs or extension cables
- If the above measures do not provide a sustainable solution, contact the manu -
facturer or a trained radio and television technician
Particular hazard
areas
Special regulations apply in areas at risk of fire or explosion
–follow the appropriate national and international regulations.
Always keep ventilation openings clear. For more information on the position of the venti -
lation openings, see section Position of the ventilation openings from page 27 .
The ambient temperature must not exceed 35 °C (95 °F).
The device must not be transported using a crane.
Risk of personal injury due to toppling of the StandUp Terminal if set up incorrectly. Only
set up the StandUp Terminal on a flat, stable surface and screw it to the wall and floor using
the supplied brackets with the help of trained personnel.
For more information on installing the StandUp Terminal, see section Installing the Stan -
dup Terminal from page 33 .