5
To set the date and time:
-
Left-hand selection dial:
select parameter
-
Right-hand selection dial:
change values
Setting ranges:
yEA
Year (20yy; 0 - 99)
Mon
Month (mm; 1 -1 12)
dAY
Day (dd; 1 - 31)
Hou
Hour (hh; 0 - 24)
Min
Minute (mm; 0 - 59)
NOTE!
If the power source is reset to factory settings via setup parameter FAC, the
date and time remain stored.
Deactivating
Easy Document-
ation
CAUTION!
Risk of data loss or data damage due to premature disconnection of the USB
thumb drive
▶
Do not disconnect the USB thumb drive until approx. 10 seconds after the
end of the last welding operation to ensure correct data transfer.
1
Unplug the USB thumb drive from the power source
The power source display shows:
Easy Documentation is deactivated.
2
Acknowledge the display by pressing the arrow key
92
Содержание TransSteel 4000 Pulse
