Establishing a
ground earth
connection
NOTE!
When establishing a ground earth connection, observe the following points:
▶
Use a separate grounding cable for each power source
▶
Keep positive cables and grounding cables together as long and as close as
possible
▶
Physically separate the welding circuits of individual power sources
▶
Do not route several grounding cables in parallel;
if parallel routing cannot be avoided, keep a minimum distance of 30 cm
between the welding circuits
▶
Keep the grounding cables as short as possible, provide a large cable cross-
section
▶
Do not cross over grounding cables
▶
Avoid ferromagnetic materials between the grounding cables and the inter-
connecting hosepack
▶
Do not wind long grounding cables - coil effect!
Route long grounding cables in loops
▶
Do not route grounding cables in iron pipes, metal cable trays, or on steel
beams, avoid cable ducts;
(routing positive cables and grounding cables together in an iron pipe does
not cause any problems)
▶
If several grounding cables are used, separate the part's ground points as far
as possible and do not allow crossed current paths under the individual arcs.
▶
Use compensated interconnecting hosepacks (interconnecting hosepacks
with integrated grounding cable)
1
3
2
1
57
EN-US
Содержание TransSteel 4000 Pulse
