Fronius TransSteel 4000 Pulse, Руководство по эксплуатации

Страница: 77 / 140

EasyJob mode
General The "Save" buttons allow up to five EasyJob operating points to be saved. Each
operating point corresponds to the settings made on the control panel.
EasyJobs can be stored for each welding process.
IMPORTANT! Setup parameters are not saved at this time.
Saving EasyJob
operating points
1
Press and hold one of the "Save" buttons to save the current set-
tings on the control panel, e.g.
- The left display reads "Pro"
- After a short time, the left display switches to the original
value
2
Release the "Save" button
Retrieving Easy-
Job operating
points
1
To retrieve saved settings, press the corresponding "Save" button
briefly, e.g.
-
The control panel will show the saved settings
Deleting Easy-
Job operating
points
1
Press and hold the relevant "Save" button to delete the memory
content of that "Save" button, e.g.
- The left display reads "Pro".
- After a short time, the left display switches to the original
value
2
Keep the "Save" button held down
- The left display reads "CLr".
- After a while, both displays show "---"
3
Release the "Save" button
77
EN-US