97
EN
Irregular wire feed speed
Cause:
Braking force has been set too high
Remedy:
Loosen the brake
Cause:
Hole in the contact tip is too narrow
Remedy:
Use a suitable contact tip
Cause:
Faulty inner liner in welding torch
Remedy:
Check the inner liner for kinks, dirt, etc. and replace if necessary
Cause:
The feed rollers are not suitable for the wire electrode being used
Remedy:
Use suitable feed rollers
Cause:
Feed rollers have the wrong contact pressure
Remedy:
Optimise the contact pressure
Wirefeed problems
when using applications with long welding torch hosepacks
Cause:
Incorrect arrangement of welding torch hosepack
Remedy:
Arrange the welding torch hosepack in as straight a line as possible, avoiding
bends
Welding torch becomes very hot
Cause:
The specification of the welding torch is inadequate
Remedy:
Observe the duty cycle and loading limits
Cause:
Only on water-cooled systems: Inadequate coolant flow
Remedy:
Check coolant level, coolant flow, for coolant contamination, etc. For further
information refer to the cooling unit operating instructions.
Содержание TransSteel 2500c
