Fronius TransSteel 2500c, Руководство по эксплуатации

Страница: 86 / 120

86
Setup parameters
for MMA welding IMPORTANT! If you reset the power source using the FAC factory setup parameter, the
hot-current time (Hti) and HotStart current (HCU) setup parameters are also reset.
HCU HotStart current
Unit: %
Setting range: 100 - 200
Factory setting: 150
Hti Hot-current time
Unit: s
Setting range: 0 - 2.0
Factory setting: 0.5
Ast Anti-Stick
Unit: -
Setting range: On, OFF
Factory setting: OFF
FAC Factory - Reset power source to factory setting
Press and hold down one of the "Parameter selection" buttons for 2 s to restore the
factory settings
- when "PrG" appears on the digital display, the power source has been reset.
IMPORTANT! When the power source is reset, all personal settings are lost.
When the power source is reset, operating points that were saved using the "Save"
buttons are not deleted, but are retained in the memory. The functions in the sec-
ond level of the Setup menu (2nd) are also not deleted. Exception: Ignition time-
out function parameter (ito).
2nd Second level of the Setup menu (see "Setup menu - level 2")