Fronius Robacta Reamer Alu 3000upm, Руководство по эксплуатации, Страница: 78 / 92

Troubleshooting
Errors in pro-
gram sequence
Parting agent does not spray (Robacta Reamer Twin only)
Parting agent container is full
Not enough spray
Adjust spray amount
Parting agent spray nozzles are blocked
Clean parting agent spray nozzles
If cleaning does not rectify problem, contact After-Sales Service -
replace parting agent spray nozzles
No signal from robot
Check connection to robot control
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Welding torch is poorly cleaned or damaged
Lifting device not adjusted properly
Adjust lifting device
Gas nozzle clamped in wrong position (not on Robacta Reamer Twin)
Adjust gas nozzle clamping device (not on Robacta Reamer Twin)
Cleaning cutter / cleaning brush not suited to welding torch shape
Fit the correct cleaning cutter / fit correct cleaning brush
Cleaning cutter / cleaning brush worn
Replace cleaning cutter / cleaning brush
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
Cleaning cutter collides with a contact tip or gas nozzle (Robacta Reamer Twin
only)
Incorrect swivel mechanism stop angle
Contact After-Sales Service - Adjust the swivel mechanism stop
angle Cause:
Remedy:
Lifting device is not moving up or down
Compressed air relief valve closed
Open compressed air relief valve
No signal from robot
Check connection to robot control
Faulty sealing in lifting cylinder
Contact After-Sales Service - replace lifting cylinder
Cause:
Remedy:
Cause:
Remedy:
Cause:
Remedy:
78