Fronius Robacta Reamer Alu 3000upm, Руководство по эксплуатации

Страница: 47 / 92

Adjusting the Robacta Reamer Alu 3000upm lift-
ing device
Adjusting the
lifting device
1
Remove protective covering (1)
2
Remove gas nozzle from torch
neck
3
Ensure that the lifting device is in
its lowest position
4
Loosen screw (2) on the lifting
device
5
Move the welding torch to the
cleaning position
(4) (4)
(2) (2)
(5) (5) (6) (6)
(3) (3)
6
Push the lifting device (3) by hand
into its highest position and hold in
place
7
Manually push cleaning motor (4)
and cleaning cutter to the cleaning
position
- see diagram (5) for welding
torch and spatter guard
- see diagram (6) for welding
torch and insulating sleeve
NOTE!
The cleaning cutter must not touch any welding torch components.
8
Fix cleaning motor (4) in this position in the lifting device (3) - tighten screw
(2) on the lifting device
9
Carry out function test on unfitted gas nozzle - push lifting device by hand to
its highest position
- The cleaning cutter must close around the contact tip without touching
it. If the cleaning cutter touches welding torch components, readjust the
lifting device
10
Fit gas nozzle to torch neck
11
Carry out function test on fitted gas nozzle - push lifting device by hand to
its highest position
- The cleaning cutter must be inserted into the gas nozzle gently, without
touching it. If the cleaning cutter touches welding torch components, re-
adjust the lifting device
12
Fit the protective covering to the cleaning device in its original position
47
EN