23
EN
Printing, if MagicCleaner is exclusively used for
printing
General remarks
WARNING!
Danger from incorrect operation.
Operating the equipment incorrectly can cause serious injury and damage.
► Do not use the functions described here until you have read and completely under
-
stood all of the following documents:
► these Operating Instructions
► all “Operating Instructions” for the system components, especially the “Safety rules”
► the safety data sheet for the printing electrolyte.
For this application, we recommend using the “Printing set (4,100,212 - not included in
MagicCleaner scope of supply). This set consists of:
-
Printing electrolyte 0.5l
-
1 x printing film for doing your own printing
-
10 x printing felts
-
1 x plastic canister
-
1 x plastic case
Imprinting film for
short-term use
Use a dot matrix printer or a mechanical typewriter for imprinting the film for short-term use.
Fix the film to a paper sheet size A4 with adhesive tape
Insert paper into printer in a way that the colored film is printed
Print text or graphics on the film
Remove colored printing film
The printing film can be used for abt 10 printings.
Preparation
Switch off the MagicCleaner disconnect it from the mains
Undo the screw-cap of the reservoir
IMPORTANT!
Before pouring the printing electrolyte into the reservoir, this must first be
emptied completely! Also, the hosepack and reservoir must be rinsed with clean water!
Fill the reservoir with printing electrolyte, up to just under the filler neck
Replace the screw-cap of the reservoir tightly
Make an earth connection between the MagicCleaner and the workpiece
Mount the print
-
ing felt on the
cleaning elec
-
trode
Using your index finger and thumb, pull the clamping plate towards the cleaning han
-
dle and turn it 90°
Using your thumb, lift the clamping plate on each side at a time and clamp the printing-
felt in place
Turn the clamping plate back 90°
1
2
3
4
1
2
3
4
5
1
2
3
