Fronius IG-TL 3.0, Руководство по эксплуатации

Страница: 114 / 140

112
Description This is of no concern if the inverter is functioning without prob-
lems and it appears only in the ‘PS Status’ Setup parameter. In
the event of an actual fault, this status code supports Fronius
TechSupport in the failure analysis.
756
Logging mode has been deactivated
Description While logging data were actively being recorded to the USB
stick, the time was reset to a point in time before switch-on.
When the error occurs, logging data recording is turned off.
Remedy Delete data from USB stick, and reactivate logging data record-
ing.
If the status code persists: Contact a Fronius-trained service
technician
757
Hardware error in the Real Time Clock module
Description A warning message is shown on the display; the inverter does
not feed energy into the grid.
Remedy If status code persists: Contact a Fronius-trained service tech-
nician
761 - 765
Provides information about the internal processor program status
Description This is of no concern if the inverter is functioning without prob-
lems and it appears only in the ‘PS Status’ Setup parameter. In
the event of an actual fault, this status code supports Fronius
TechSupport in the failure analysis.
766
Emergency power limiter has been activated (max. 750 W)
Description A warning message is shown on the display.
Remedy If status code persists: Contact a Fronius-trained service tech-
nician
767
Provides information about the internal processor program status
Description This is of no concern if the inverter is functioning without prob-
lems and it appears only in the ‘PS Status’ Setup parameter. In
the event of an actual fault, this status code supports Fronius
TechSupport in the failure analysis.
768
Power limit is different in the hardware modules
Description A warning message is shown on the display.
Remedy If status code persists: Contact a Fronius-trained service tech-
nician