Fronius Eco 25.0-3-S, Руководство по эксплуатации

Страница: 37 / 196

37
EN
ENERGY YIELD The following settings can be changed/set here:
- Counter deviation / Calibration
- Currency
- Feed-in tariff
- CO2 factor
Fan To check that the fan is working correctly
- Use the "Up" and "Down" keys to select the desired fan
- Testing of the selected fan is initiated by clicking "Enter".
- The fan will continue to run until the operator exits the menu by pressing "Esc".
IMPORTANT! Nothing will show on the inverter display if the fan is working. The only way
to check how the fan is working is by listening and feeling.
Since the contrast is temperature-dependent, it may be necessary to adjust the setting
under the "Contrast" menu item when the environmental conditions change.
Illumination
Initial setting for inverter display illumination
The "Illumination" menu item only relates to the inverter display backlighting.
Setting range AUTO / ON / OFF
Factory setting AUTO
AUTO: The inverter display backlighting is activated by pressing any key. If no key
is pressed for 2 minutes, the display backlighting will go off again.
ON: The inverter display backlighting remains permanently on when the inverter
is active.
OFF: The inverter display backlighting is permanently switched off.
Setting range Currency / Feed-in tariff
Counter deviation / calibration
Calibrating the counter
Currency
Set the currency
Setting range 3 characters, A-Z
Feed-in tariff
Set the remuneration rate for energy fed into the grid
Setting range 2 digits, 3 decimal places
Factory setting (depends on country setup)
CO2 factor
Setting the CO2 factor of the energy fed into the grid
Setting range Test fan #1 / Test fan #2 (depending on the device)