Fronius AccuPocket 150/400 TIG, Руководство по эксплуатации, Страница: 45 / 88

6
Use the other end of the grounding cable to establish a connection to the
workpiece
WARNING!
Danger from electric shocks.
This can result in serious injury and damage to property.
▶
As soon as the power source is switched on, the electrode in the welding
torch is live. Make sure the electrode does not touch any persons or elec-
trically conductive or earthed parts (e.g. the housing, etc.).
7
Press the On/Off button for at least two seconds to turn on the power
source
-
the welding current indicator lights up
- the display shows the specified welding current
Setting the gas
pressure
Welding torch with torch trigger
(and TIG Multi Connector plug)
Welding torch with torch trigger (and
TIG Multi Connector plug):
1
Press the torch trigger
- shielding gas flows
2
Set the desired gas flow rate on
the pressure regulator
3
Release the torch trigger
TIG welding
1
Select TIG welding with the welding process button
the TIG welding indicator lights up
2
Press the setting value button until
the welding current indicator lights up
3
Adjust the welding current using the adjusting dial
When using a welding torch with a torch trigger and TIG Multi Connector plug
(with 2-step mode factory setting):
4
Place the gas nozzle down on the ignition location, ensuring there is a gap of
approx. 2 to 3 mm (5/64 to 1/8 in.) between the tungsten electrode and the
workpiece Gap exists
5
Gradually tilt the welding torch up until the tungsten electrode touches the
workpiece
6
Pull back and hold the torch trigger
- Shielding gas flows
7
Raise the welding torch and rotate it into its normal position
- The arc ignites
45
EN