FS4.1893-Manual-30.18XX.02-EN-Version02_R1
FROMM
It is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2013
www.fromm-stretch.com
55
ERRORS DURING OPERATION
THE HORSESHOE TURNTABLE DOESN’T START ROTATING
Problem suggestion
Possible solution
- The machine doesn’t start
and generates an error on
the display
- Check if something is blocking the safety-device of the table
- Check the wiring according diagram.
- The machine doesn’t start
and doesn’t generates an
error on the display
- Remove the plate (3) covering the distance between mast and
turntable. (
Fig. 3
)
- Check that 2x rolls (1) are still pressed against the turtable (2).
(
Fig. 1
)
- If you discover a broken roll or excessive wearing we adivise
to replace the rolls.
- Clean the side surface (6) of the table. (
Fig. 1
)
- Increase the tension on the rolls by adjusting the bolts (4) dont
forget to contra block the bolt with nut (5).
- Higher force on the rolls can give more wearing!!
Fig. 1
Fig. 2
Fig.3
Should the problem persist, contact the Customer After-Sales Service of MANUFACTURER
THE MACHINE DOESN’T STOP IN THE ZERO POSITION
Problem suggestion
Possible solution
- The machine stops in the wrong position
- The machines has been switched OFF, not
being in the ZERO position.
- Follow below sequence to RESET the ZERO
position.
RE / FIND ZERO POSITON
Press stop and immediate after press reset and hold both buttons for 5
seconds.
The turntable starts to rotate and stops at the correct position
Should the problem persist, contact the Customer After-Sales Service of MANUFACTURER
4
3
1
5
2
6
