FS4.1893-Manual-30.18XX.02-EN-Version02_R1
FROMM
It is forbidden to duplicate this manual or parts of it in any way or any form without written permission of the author © 2013
www.fromm-stretch.com
7
GENERAL
The FS4xx machine is an semi-automatic pallet wrapping machine.
The operator has to place the pallet on top of the turntable and connect the film on the pallet.
The tension or stretch can be adjusted on the operating panel or carriage.
Depending on the functionality of the machine, the operator can start the wrapping process or initially
he has to setup the wrapping cycle, speed of turntable and carriage.
The process will be activated by pressing the start button. After completing the cycle, the machine will
stop in his original start position, the film can be disconnected and the operator can take away the
pallet from the turntable.
•
This manual is only intended for a semi-automatic pallet stretch wrapping machine, mentioned at
page one, as delivered by FROMM Stretch Wrapping Division.
•
FOR EVERYTHING IN THIS MANUAL IS VALID, IF APPLIED!
•
THE ORIGINAL, SIGNED FACTORY MANUAL HAS TO REMAIN INSIDE THE ELECTRICAL BOX
OF THE MACHINE, TOGETHER WITH THE MACHINE ELECTRICAL PLAN AND INVERTER
MANUALS.
A special bracket FS3.0250 can be purchase to keep this documentation together.
•
This so-called turntable machine can be build into the floor.
A support frame for building the machine in the floor can be supplied as an option.
•
Pre- stretching (Stretching out) the film prior to application on the goods reduces the costs of
packaging and is easier on the environment. (Available pre stretch depend on the model)
•
Refer to chapter for the technical data, which describes the installation in detail and for the
complete size of the installation.
•
Read carefully at least the chapters
HANDELING AND TRANSPORT
and
INSTALLATION.
•
For safety reasons the entire instruction manual should be read before setting in operation the
machine/installation, solving failures and executing maintenance.
•
We particularly draw your attention to the chapters
SAFETY INSTRUCTIONS
and
WARNINGS
which point out the intended use and unsafe situations that could not be prevented in the design and
manufacture of the wrapping machine.
•
It is strictly prohibited to tamper with the machine It is prohibited to feed the machine with unforeseen,
corrosive or inflammable products since the machine is not the explosion-proof type.
•
The duration of guarantee is provided the following are observed: the use for which the machine was
designed, built and protected, in addition to recommendations, information - including matters of
general knowledge - details plus the safety and health technical limits notified to by the Manufacturer
to the User by virtue of the operating use.
•
We cannot accept any claim for warranty if non-original spare parts are utilized.
•
If the machine is used beyond its operating limits and if the manufacturer's features are altered in any
way, such use is considered
improper.
In this case
MANUFACTURER
is relieved of any liability for
injury/damage caused to people/property due to failure to comply with these guidelines.
•
For all the aforementioned reasons, we recommend that our customers always notify the Service
Department.
