Assembly | 6
M1980822_en | Installation instructions Wood chip boiler T4e 20-180
55
6.5.2 Laying cables
r
Remove the insulating cover and thermal insulation
r
Remove the retaining screw and contact washer from the controller cover
r
Slide the controller cover backwards and lift off
r
Wire all the components via cable duct (A) in the side panel to the controller box
Ä
Drive for feed screw / discharge system
Ä
Limit switch on gravity shaft cover (not pre-wired)
r
Plug the following components into the cable that is already in place
Ä
Stoker drive
Ä
Glow igniters
r
Ensure that the cables do not touch the hot boiler components