8
FILTER
HOSE
CLAMP
HOSE
ADAPTER
HOSE
CLAMP
HOSE
ADAPTER
1 1/2" OR 1 1/4"
FLEX HOSE
1 1/2"
X
1 1/2"
X
1 1/4"
HOSE ADAPTER
HOSE
CLAMP
PUMP
CHECK
VALVE
TO
POOL
TOOLS NEEDED
Screwdriver
Pipe Wrench
MATERIALS NEEDED
Pipe Thread Tape
or Sealant
Two hose adapters
1½” X 1½” X 1¼”
Two Sections of 1½”
or 1¼” Flex Hose (one
provided with filter)
Two
Hose
Clamps
RECOMMENDED
4-8 psi Back Pressure
To avoid over or under
chlorination, replace eyeball
fittings in the return jets to a
smaller or larger size to adjust
back pressure. For best results
use King Technology’s pressure
gauge, order Part No.
01-22-4000.
Apply pipe thread tape or
sealant to the threaded end of
both hose adapters.
1.
Installation with Flex Hose Only
Screw adapters into each end
of FROG Leap Infuzer. Hand
tighten. Finish tightening by
turning 1 to 2 revolutions with
pipe wrench.
DO NOT OVER
TIGHTEN.
2.
Attach the filter section of flex
hose to one hose adapter and
the return section of flex hose
to the other hose adapter
with clamps and tighten with
screwdriver. Bi-flow valve
design allows water flow
installation in either direction.
3.
To prevent damage to heaters or filters, install a
corrosion resistant check valve
which will reduce
the back flow of chlorine gas when the system is
turned off.
4.
For better stability, FROG
Leap Infuzer may be
mounted on a treated
wood base using
Phillips
pan head screws,
one
in front and two in back.
If you have questions
about stability, please
contact your dealer or King
Technology.
5.
The FROG Leap Infuzer should always be installed between the filter and pool (or between heater and
pool if applicable).
Never install
FROG Leap
Infuzer before the heater or damage to the heater could
occur.
TO POOL
PUMP
FILTER
HOSE
CLAMP
HOSE
ADAPTERS
HOSE
CLAMP
1 1/2" OR 1 1/4"
FLEX HOSE
CHECK
VALVE
Sand Filter
DE and Cartridge Filter
