10
1½” Male Adapter
(slip x MPT)
or
2” Female
Adapter
(slip x FPT)
Hard-Plumbed Installation
Do NOT install FROG
Pool Tender Cycler off-
line.
Following Primer directions, brush Primer on the inside of the
adapters and to ends of pipe. Repeat this process with PVC
cement following manufacturer’s directions on that product.
Measure the
distance between
the outside adapters
and cut out a section
of pipe 3” less than
that dimension.
Allow a minimum of
12” above and on
each side of FROG
Pool Tender Cycler to
ensure room for easy
replacement of FROG
Pool Tender Mineral
Chamber and FROG
Pool Tender Chlorine
Chamber.
Insert PVC pipe into adapters with
a twisting action. Hold in place 5 to
10 seconds to bond.
TOOLS NEEDED
Hacksaw
MATERIALS NEEDED
Tape
Measure
SECURE CYCLER
To prevent damage to heaters
or fi lters, see your dealer about
installing a
corrosion resistant
check valve
which will reduce the
back fl ow of chlorine gas when the
Cycler is turned off.
2.
1a.
1.
1b.
3.
Pipe Wrench
Bi-fl ow valve design allows
installation in either fl ow
direction.
Pipe Thread Tape
or Sealant, Primer and
PVC Cement
If using
male adapters
, apply
pipe thread tape or sealant to the
threaded end of each adapter.
Screw adapters into each end of FROG Pool Tender Cycler following
directions for a male adapter or a female adapter. Hand tighten. Finish
tightening by turning 1 to 2 revolutions with a pipe wrench.
DO NOT OVER TIGHTEN.
4.
5.
The FROG Pool Tender Cycler should always be installed
between the fi lter and pool (or between heater and pool if
applicable). Never install FROG Pool Tender Cycler before
the heater or damage to the heater could occur.
Do NOT install in copper pipe if using
FROG Pool Tender Chlorine Chamber
as chemical corrosion may lead to
pipe failure.
Primer
For better stability,
FROG Pool Tender
Cycler may be mounted
on a treated wood base
using
Phillips pan head
screws,
one in front
and two in back. If you
have questions about
stability, please contact
your dealer or King
Technology.
Primer
PVC
Cement
PVC
Cement
12"
12"
12"
If using
female adapters
, apply
pipe thread tape or sealant to the
threaded end of each cycler port.
OR
