Frigomat Ketty 05 Series, Руководство по использованию и обслуживанию

Страница: 27 / 50

7 ENGLISH
3.3 MACHINE OUTFIT
No. 1 cleaning rods
No. 1 Gasket extractor
No. 2 piston gaskets
No. 2 handle gaskets
No. 2 door gaskets
No. 2 beater shaft bushing
No. 1 Agitator stuffing box
No. 1 Lubricant FRIGOMAT
No. 1 fuse 5x20 – 0,1 amp
No. 1 fuse 5x20 – 0,63 amp
Manual of use and maintenance
Declaration of conformity
Certificate of guarantee
3.4 COMMISSIONING
Bring the machine to the place of employment and check that everything is all right as far
as installation concerns:
correct power supply
place the machine far away from walls or other obstacles (at least 10 cm sideways and
30 on the back).
Make sure that the supply voltage and power comply with the values reported on the
rating plate placed on the back panel;
Connect the machine to the power supply; upstream the machine, arrange an omni
polar master switch with minimum contact opening equal to 3 mm and adequate power,
interlocked with fuses to allow plugging and unplugging at open circuit.
Connect the feeder to a type-approved plug: the
feeder shall be well stretched, to avoid rolling
and overlapping. It shall not be exposed to
possible shocks or tampering attempts and far
from liquids, water and heat sources. It shall not
be damaged, otherwise make it be replaced by
qualified personnel with another section and type
3G1.5 H07RN-F (230/1), before connecting the
machine to the mains.
Arrange the connection of the yellow-green wire
to a good earth connection
Before starting the machine unscrew the fixing
knobs and remove the front door (pos.2) and
mixer (pos.1)
If required grease with outfitted lubricant