Friendly Robotics robomower RL1000, Руководство по обслуживанию

Страница: 78 / 213

3
3.2.5 Automatic Mowing Problems (con.)
3.2.5.6
23
Is there another
activated
Perimeter Switch
near the plot?
Was a ‘No wire
signal’ message
displayed when
the Robomower
stopped?
When does
the mower
cross the
wire?
What type of
wire did it
cross?
Robomow crosses
Perimeter Wire
(stops with ‘Start
elsewhere’
message)
YES
NO
YES
NO
The minimum distance
between 2 adjacent
plots activated
simultaneously should
be greater than 13ft/4m
Is there another
adjacent plot
connected to the
same Perimeter
Switch?
NO
YES
The minimum distance
between 2 adjacent
plots activated by the
same P. Switch should
be greater than 5ft/1.5m
Is there a place
where the distance
between P. Wires
in the activated
plot is less than 5ft
/1.5m?
Avoid creating corners
sharper than 90 degrees in
the Perimeter Wire.
Perform ‘Edge calibration’
Usually a zigzagging motion
is preceding the wire
crossing (please refer to
section 5.3.2)
During
‘Scan’
Perimeter
Island
Perimeter
Wire
Inspect the double wires
between the Perimeter
Island and the Edge for
wire crossing or wire short
Reinstall this part of the
wire, uncrossing them (the
wire may be cut and re-
spliced if necessary)
Too tightly pegged double
wires can cause shorts and
low Wire Sensors readings.
Double wires can be found
between:
P. Island and P. Wire
P. Wire and P. Switch
Two different plots
Refer to the setup rules
of wire placement,
particularly corners and
distances between
perimeter wires.
Test Wire Sensors
(replace if needed)
YES
The Robomow may take a
few seconds to realize that
the wire signal is missing.
Check the Perimeter Switch
Change the setup to
min. 5ft/1.5m between
2 perimeter wires in
the same plot
During
'Edge’