Friedrich MRM09Y1J, Руководство по обслуживанию и запасным частям

Страница: 30 / 135

30 PB
OPERATION
Remote Control Description
Technical Information
Press " " and " " buttons simultaneously to lock or unlock the keypad. If the remote controller is locked,
case, pressing any button, blinks three times. is displayed. In this
Press this button to activate / deactivate the Turbo function which enables the unit to reach the preset temperature in the shortest time. In
COOL mode, the unit will blow strong cooling air at super high fan speed. In HEAT mode, the unit will blow strong heating air
at super high fan speed. (This function is not applicable for some models).
Press this button to go into the SLEEP operation mode. Press it again to cancel this function. This function is available in COOL or DRY
mode to maintain the most comfortable temperature for you.
Press LIGHT button to turn on the display's light and press this button again to turn off the display's light. If the light is turned on, is
displayed. If the light is tunrned of f, disappears.
When the unit is OFF, press "MODE"and " " buttons simultaneously to switch between °C and °F .
During operation, point the remote control signal sender at t he receiving window
on indoor unit.
The distance between signal sender and receiving window should be no more than
8m, and there should be no obstacles between them.
Signal may be interfered easily in the room where there is fluorescent lamp or
wireless telephone; remote controller should be close to indoor
unit during operation.
Replace new batteries of the same model when replacement is required.
When you don’t use remote controller for a long time, please take out the batteries.
If the display on remote controller is fuzzy or there’s no display, please replace
batteries.
Sketch map for
replacing batteries
1.Press the back side of remote controller marked with“ ”as shown in the fig, and then push out the cover
of battery box along the arrow direction.
2. Replace two 7# (AAA 1.5V) dry batteries, and make sure the position of “+” polar and “-“ polar are correct.
3. Reinstall the cover of battery box.
Panel
Emergency operation
switch
Lock Controller: Combination
Switching Between °C and °F