12
7.
Ensure that the “Reset” and the “Hard-Wired Siren
tamper detect” jumper links are set in the OFF position.
8.
Connect battery leads to both back-up batteries and
refit batteries.
LEFT Battery: Red lead to the Red (
+
)
battery
terminal
Blue lead to the Black (
-
) battery
terminal
RIGHT Battery: Blue lead to the Red (
+
)
battery
terminal
Black lead to the Black (
-
) battery
terminal
IMPORTANT:
Take care when connecting battery
leads to the batteries as connecting incorrectly could
damage the batteries or the Control Panel.
Note:
The Power LED may flash to indicate that the
unit is being operated from the back-up batteries and
that mains supply is not present.
9.
If fitted, remove the plastic film covering the LCD
display and on the display window on the cover.
10.
Close the lid of the Control Panel and fasten the
cover fixing screws.
11.
Plug in and switch ON the Power Supply Unit, (the
Power LED should illuminate).
12.
If required, connect the Control Panel to the
telephone line using the cable supplied by inserting
small RJ11 plug into socket marked LINE located on
the bottom edge of the Control Panel. If the cable
supplied is not long enough to reach a suitable phone
point then it will need extending using a coupler and
extension lead (not supplied).
Note:
If the Control Panel Tamper alarm sounds during
the installation reset the alarm by pressing
on the Control Panel.
IMPORTANT!
The keys must be pressed firmly
and within 3 seconds of each other. If you make a
mistake, press and start the sequence again.
CONFIGURING THE CONTROL PANEL
HOUSE CODE
With unit in Standby mode (Power LED only
illuminated).
1.
Press
‘
1. USER SETUP
’ will be displayed.
This puts the Control Panel into Programming Mode.
2.
Use the and buttons to scroll through
the menu until ‘
2. SYSTEM SETUP
’ is displayed and
press .
‘
2-1 Learn House Code
’ will be displayed.
3.
Press
.
The current House Code setting will be displayed.
4.
The new system House Code can be programmed
either directly at the Control Panel or via a Remote
Control Unit as follows:
At the Control Panel:
Press buttons 1-8 on the Control Panel to configure
the display so that the required House Code is
displayed on the screen. As each button is pressed the
corresponding digit in the House Code will change to
the opposite state, (“0” or “1”).
1 = House Code DIP Switch On/Up
0 = House Code DIP Switch Off/Down
Using a Remote Control:
With the required House Code already configure on the
Remote Control, press .
The Control Panel will beep twice to acknowledge the
signal. The display will change to show the received
House Code on the lower line of the display beneath
the corresponding DIP switch numbers (1-8).
���
��
������
�����
�����
��
������
����������������������
����������������
������������
�������
������
����
������
����
,
,
User Access Code
,
,
Master User Access Code
