A
A
B
B
C
D
A
A
B
C
GB
9
Using the paper template, trace on the ceiling the position of the
two fixing brackets and the two rear screws. Using a suitable drill,
make the holes and insert the toggle bolts (2 for each bracket);
fix the two brackets. Do not over-tighten the screws. Position the
machine on the two brackets, keeping it in position and then fix the
two screws into the rear toggle bolts, one on each side.
Make sure that there is sufficient inclination of the unit towards the
drainage pipe to facilitate the water drainage.
Fully tighten all 6 fixing screws.
The installation of SLS units (with cooling effect) in horizontal
position is prohibited. .
Carefully check the inclination of the exhaust pipe. Any
counterslope of the discharge line can cause water leakage
In the case in which the cooler-convector is installed in a horizontal
position, to guarantee the safety of the cleaning/filter replacement
operations it is obligatory that the two clamps, in the supplied bag
together with the instruction manual and the accessories, are
mounted by the installer.
Install braces to prevent the fall of the grid.
-
Separate the two clamps;
-
open the front grill and completely unscrew the fixing screws
on the springs;
-
fix the two clamps, blocking them by retightening the screws;
- fix the other part of the clamp to the grill using the supplied
screw;
-
close the grill.
Horizontal or ceiling installation (SL)
Mounting front grill safety support (SL)
A
toggle bolts
B
brackets
C
screws
D
drainage pipe
A
Ties
B
Screws fixing springs
C
grid
