FRESENIUS MEDICAL CARE
MEDICAL TREATMENT CHAIR
INSTRUCTION MANUAL - T688B Series
Page 10 of 20
IFU T688B V2 Apr 2021
4.3
FABRIC STANDARDS
Unless otherwise stated, standard upholstery fabrics used on these chairs conform to the
following Australian Standards:
-
Flame Retardant tested to AS1530.3*
-
UV Stable - tested to ISO 105-B02 Colour fastness to artificial light: Xenon arc fading
lamp test*
*NOTE: This is for Fresenius Medical Care standard supply fabric. Customer specific fabric may
not meet these standards.
4.4
TROUBLE-SHOOTING
In the event the chair fails to operate correctly please take the following steps
prior to
contacting Fresenius Medical Care or its authorised agent.
1. Check the power point is active.
2. Check that the power cord is not damaged or worn. Check that the chair is plugged in and
switched on correctly as indicated by the green indicator light on the
nurse’s hand control.
3. Ensure that the batteries have been on charge for 24 hours minimum. This should occur at
least every 5 days.
4. Ensure there are no nicks or cuts in the hand control or actuator cables.
5. Determine what is not operating as follows:
-
The leg motor
(vertically mounted under the seat)
Depress the hand control button for the leg rest and the footrest should move.
-
The back motor
(mounted behind the backrest)
Depress the hand control button for the back and the back should raise or lower.
-
The lift columns
(mounted on top of the base)
Depress the hand control button for the HI/LO control and the chair should raise or
lower.
6. Take note of the serial number
(
)
of the chair. This can be found on the Type Label
attached to the chair. An example of the Type Label is in section 8.2.7.
7. If you are unsure about any aspect of the above steps, please contact Fresenius Medical
Care Seating at the contact details provided in Section 5 of this manual.
