
7
81
53
1.
Make sure that
the Power Cord
(70) is unplugged.
Be careful not to
pinch the Power
Cord.
Slide the Upright Cover (not shown) off the
Upright (81).
Orient the Upright (81) and the plastic tie as
shown. Set the Upright on the tabs on the Frame
(53). Attach the Upright to the Frame with four
3/8" x 3" Screws (1) and four 3/8" Star Washers
(2). Start all four Screws before tighten-
ing any of them. Be careful not to pinch the
Upright Wire (111).
111
1
1
2
2
Plastic Tie
!
!
1
70
Tabs
• Assembly requires two persons.
• Place all parts in a cleared area and remove the
packing materials. Do not dispose of the packing
materials until you finish all assembly steps.
• After shipping, there may be an oily substance
on the exterior of the treadmill. This is normal. If
there is an oily substance on the treadmill, wipe
it off with a soft cloth and a mild, non-abrasive
cleaner.
• To identify small parts, see page 6.
• Assembly requires the following tools:
the included hex key
one Phillips screwdriver
To avoid damaging parts, do not use power tools.
ASSEMBLY