
16
4. Change the incline of the treadmill as desired.
To change the incline of the treadmill, press the
Incline increase and decrease buttons or one of the
Quick Touch Incline buttons numbered 0 to 15.
Each time you press the Incline increase or
decrease button, the incline will change by 0.5%.
If you press one of the numbered Quick Touch
Incline buttons, the incline will gradually change
until it reaches the selected incline setting.
5. Select a display mode and monitor your prog-
ress with the display.
When the manual
mode is selected,
the console offers
six display modes.
The display mode
that you select will
determine which workout information is shown.
Press the Display button repeatedly to select the
desired display mode.
As you walk or run on the treadmill, the upper dis-
play can show the following workout information:
• The elapsed time.
• The distance that you have walked or run.
• The speed of the walking belt.
• The incline level of the treadmill.
• The approximate number of calories you have
burned.
• The approximate number of calories burned per
hour.
• Your exercise intensity in METs. One MET is the
amount of energy you use while resting.
• Your walking or running pace, in minutes per
mile or minutes per kilometer.
Regardless of which display mode you select, the
speed or incline setting will appear in the display for
a few seconds each time you change the setting.
The lower right and lower left displays will show the
speed of the walking belt and incline of the treadmill.
As you switch between workouts and the manual
mode, the console will keep track of the total
distance that you have walked or run and the
approximate number of calories you have burned.
You can keep your totals even when you switch
to a new workout. To reset the console, press the
Clear button.
6. Measure your heart rate if desired.
Note: If you use the handgrip heart rate moni-
tor and the chest heart rate monitor at the same
time, the console will not display your heart
rate accurately. See page 12 for information on
the chest heart rate monitor.
Before using
the handgrip
heart rate mon-
itor, remove
the sheets of
plastic from the
metal contacts.
In addition,
make sure that
your hands are
clean.
To measure your heart rate, stand on the foot
rails and hold the contacts for approximately
ten seconds—avoid moving your hands. When
your pulse is detected, a heart-shaped indicator
will flash in the display and your heart rate will be
shown. For the most accurate heart rate read-
ing, continue to hold the contacts for about 15
seconds.
VO2 Max
Contacts