Franzis PE01, Инструкция по эксплуатации

Страница: 18 / 20

ASSEMBLING THE ENGINE ASSEMBLING THE ENGINE
34 35
Step 39. Spark
plugs
Insert the spark plugs into
the holes in the upper part of
the cylinder heads. Carefully
note the markings on the top
of the distributor cap; follow
the wire that exits from hole
#1 and insert it into cylinder
number 1 as shown. Repeat
for wires/cylinders 2, 3, 4, 5
and 6.
Use the clip (72) provided to
secure the wires for cylinders
4, 5 and 6 so they are routed
neatly over the cooling fan.
Step 37. Cooling fan
assembly
Assemble the cooling fan components
as shown. Attach the rear cover (78) to
the fan housing (34) first, and secure with
two screws. Slide the fan (42) over the shaft,
followed by the fan pulley (26). Secure the
pulley to the fan using a screw and washer.
Check that the fan spins freely; if necessary,
loosen the screw slightly.
Step 38. Cooling fan
installation
Insert the clip on the bottom of
the cooling fan assembly into
the slot in the crankcase.
Fit the fan drive belt – this fits
over the crankcase pulley
and the fan pulley.