67
FCC Notice
This device complies with Part 15 of the FCC
Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful
interference, and (2) This device must accept any
interference received, including interference that
may cause undesired operation.
Warning
: Changes or modifi cations to this unit
not expressly approved by the party responsible
for compliance could void the user’s authority to
operate the equipment.
NOTE
: This equipment has been tested and found
to comply with the limits for a Class B digital
device, pursuant to Part 15 of the FCC Rules.
These limits are designed to provide reasonable
protection against harmful interference in a
residential installation. This equipment generates,
uses and can radiate radio frequency energy
and, if not installed and used in accordance with
the instructions, may cause harmful interference
to radio communications. However, there is no
guarantee that interference will not occur in a
particular installation. If this equipment does
cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try
to correct the interference by one or more of the
following measures:
–Reorient or relocate the receiving antenna.
–Increase the separation between the equipment
and receiver.
–Connect the equipment into an outlet on a
circuit diff erent from that to which the receiver is
connected.
–Consult the dealer or an experienced radio/TV
technician for help.
NOTE
: This unit was tested with shielded cables on
the peripheral devices. Shielded cables must be
used with the unit to insure compliance.
NOTE
: The manufacturer is not responsible
for any radio or TV interference caused by
unauthorized modifi cations to this equipment.
Such modifi cations could void the user’s authority
to operate the equipment.
Device Disposal
✓
This device should be disposed
through your local electronic
product recycling system – do not
throw into the trash bin.
Packaging Disposal
✓
Please save this User’s Guide and all
packing materials, as they contain
important information. In case of
disposal, please refer to your local
recycling system.
Recycling and Disposal
This unit may change operating
modes, lose information stored in
memory, or fail to respond due to
electrostatic discharge or electrical
fast transients. Normal operation of
this unit may be re-established by
pressing the reset key, by pressing
, or by removing and replacing
the batteries.
LDS-1990_RevA_eng.indd 67
LDS-1990_RevA_eng.indd 67
3/4/09 8:03:02 PM
3/4/09 8:03:02 PM
