WireOrLess Controller V3.16
Set the ID to be used and pair to the wireless receiver
Switch off the controller. (Center position of the power switch.)
Select the desired ID on the Carrera receiver.
Keep the crossover button pressed down.
Move the power switch to the right (activation of wireless mode).
Receiver acknowledges programming with "7-segment round trip". Controller ready to start.
When switching on the controller, the number of flashes indicates which ID it is programmed to.
Activating the configuration mode
For configuration, the controller must first be paired with the receiver and the receiver must be
active during configuration. Alternatively the controller can be set to cable mode including the cable
being connected to the powered Control Unit.
Switch off the controller.
Keep the gas control knob completely pressed (full throttle) and the switch button pressed. Hold
both and now switch on the controller via its power button. (In radio mode: switch to the right, in
cable module: switch to the left).
LED lights up.
Release the switch button
Release the trigger
The configuration starts.
The configuration is based on the Speedflow Wireless programming
The controller shows the currently selected configuration by the number of flashes it emits. It
continuously repeats the number of flashes, separated by a pause.
The desired configuration value is selected by briefly pressing the switch button. A short press of the
button selects the next possible value for the configuration.
The selected value is stored by keeping the switch button pressed until the LED flashes quickly,
confirming the storing of the configuration.
