Afterwards it must be tuned in again to the desired receiver.
If you have reset the controller to its default settings, we recommend to configure the start and full
throttle trigger point for your controller again for optimal operation. See "Set the trigger position
from which the car starts" or "Set the trigger position from which the car runs at full throttle".
Standby / power saving mode
After 5 minutes without use, the controller goes into sleep mode. This reduces the power
consumption to a tiny fraction. Saving battery power in case you forget to switch it off.
Cable operation
Switch off the controller. (Center position of the on/off switch.)
Plug the supplied cable into the bottom of the controller housing. The supplied cable has two
different plugs. The plug with the central latch is plugged into the controller.
Plug the other end of the cable into the control unit or expansion box.
Set controller to cable operation
Move the On / Off switch to the far left.
The configuration menu and the quick menu can also be reached in cable mode - see above – in this
case to switch on the controller move the on/off switch to the left.
In cable mode the controller also works without batteries.
Default values
The controller is ready for immediate use and only needs to be programmed to your wireless
receiver. During the final test, we adjusted the start point and full-throttle point specifically for your
controller.
Speed steps 44Plus
Launch Control active
Curve 1 active
Default starting point
Full throttle point preset
