In case you do not want to program all options you can stop the programming sequence earlier. Just
keep in mind, that each step is only stored after the fast confirmation flashes have been observed.
Quick menu -- NCE FET curve
There are original decoders in circulation, which have a very aggressive performance curve. The topic
was intensively discussed in freeslotter in late 2019, early 2020. Our customers asked us if we could
help and have an extra soft mode to reduce the aggressive behavior of these decoders.
To make driving with these decoders much easier, you can activate a compensation mode in the
WireOrLess controller which neutralizes this behavior. All further settings of the power curves, as
described above, are of course retained.
Activation/deactivation:
Switch off controller (middle position)
Keep the gas completely pressed through and
Move the On / Off switch to the right.
Release the trigger.
Current programming is displayed:
- 1 x flashing deactivated
2 x flashes NCE-FET compensation curve is active
Selection: press briefly\ Save: press and hold until LED flashes quickly.
Do not forget to save via a long press until you see the LED flashing!
Resetting to factory default settings
Switch off the controller. Keep trigger and turnout button pressed during power on and keep both
pressed for about 10 seconds.
The controller acknowledges the reset after about 8 seconds with a steady flashing signal. Now the
controller can be switched off and on again. It was reset to the factory settings (DEFAULT).
